unprocessed raw mesh export without quadric simplification.

  • 1 Replies
  • 230 Views

0 Members and 1 Guest are viewing this topic.

Offline siriux

  • *
  • Fractal Freshman
  • *
  • Posts: 7
« on: April 02, 2018, 07:38:34 AM »
Hello everbody

I am a newbie in Mandelbulb   ;)

I trie to export the fractals as a mesh in  the optimum resolution an quality. I think thats the unprocessed raw mesh export with the MB3DMeshMerge. But it seems it's not possible to export meshes in this way without quadric simplification. I unchecked in MB3D export and in the MB3DMeshMerger the quadric simplification, but the meshes are simplificated regardless.

If I export the mesh directly as an OBJ then it works without quadric simplification.

Is there a way to export without quadric simplification also over unprocessed raw mesh export?




Linkback: https://fractalforums.org/mandelbulb3d/13/unprocessed-raw-mesh-export-without-quadric-simplification/1142/

Offline siriux

  • *
  • Fractal Freshman
  • *
  • Posts: 7
« Reply #1 on: April 02, 2018, 01:56:16 PM »
Also if I change the values in unprocessed raw mesh export (Retain ratio = 1: Agressivness = 0) it has no effect. The meshes are always simplificated very strong.

In the direct export to opj, this value changes have an effect, but not in the unprocessed raw mesh.

Is this a bug?


xx
export mesh sequence?

Started by ouroboros on Forum Help And Support

1 Replies
307 Views
Last post April 06, 2018, 10:12:31 AM
by siriux
clip
Export two different mesh from the same fractal - Mandelbulb3D - JosKlein

Started by cambriano on Mandelbulb3d

2 Replies
213 Views
Last post October 29, 2018, 01:16:53 PM
by cambriano
xx
Export voxel layer

Started by monicao on Mandelbulber

2 Replies
304 Views
Last post September 01, 2018, 04:30:43 PM
by monicao
clip
Point Cloud export

Started by Arnold3456 on Mandelbulb3d

2 Replies
313 Views
Last post February 15, 2018, 05:53:51 PM
by spain2points
xx
Mandelbulber 2.20 MeshLab Export Fractale --> Unreal Engine 4

Started by meletou on Francais

0 Replies
87 Views
Last post January 29, 2020, 08:00:25 AM
by meletou